Flat Seam Panel (FSP-12)

Flat Seam Panel

Features

  • Corrective leveled for superior flatness
  • Available with up to two stiffener beads
  • Tongue and groove leg provides for a flush fit
  • 30-year non-prorated finish warranty
  • Panel lengths up to 25’
  • 38 stocked colors (24 ga. steel)
  • 16 stocked colors (22 ga. steel)
  • 36 stocked colors (.032 aluminum)
  • 20 stocked colors (.040 aluminum)
  • Galvalume Plus available

Overview

PAC Flat Seam Panels (FSP-12) are designed for wall, fascia and soffit applications where a flush or flat appearance is desired. A tongue and groove style interlock and concealed fastening system improves the flush appearance while providing good strength. Panels are formed to length to minimize field cutting. Maximum recommended panel length is 25’ with a minimum panel length of 4’.and are available in a tradition 12” width.

Stiffening Beads

The Flat Seam Panels are available with two (optional) stiffening beads. Stiffening beads are recommended for longer panel lengths.

Trim

All flashing and trim shall be fabricated by manufacturer or qualified fabricator. Flashing shall be produced from PAC-CLAD aluminum or steel flat sheets. A 30-year non-prorated finish warranty can be supplied covering finish performance. Vinyl masking is recommended on all fabrication applications where extra handling is expected.

Installation

On wall applications PAC Flat Seam Panels shall be installed over a solid substrate with appropriate 30# felt and/or ice and water shield, or in limited applications over framing sections. When used in a soffit or windscreen application, panels must be fastened (stitched) through side joints. Consult a local architect/engineer for requirements of local codes and conditions.

Flat Seam Panel