PAC Flush panels are designed for wall, fascia and soffit applications where a flush or flat appearance is desired. A rounded interlock leg and concealed fastening system improves the flush appearance while providing additional strength. Panels are factory-formed to length to minimize field cutting. Maximum panel length is 25’ and minimum panel length is 4’.
PAC Flush panels are available in on-center dimensions designed to complement our roofing panel product line. Flush panels are available in two configurations: Flush panel and Reveal panel.
The Flush panel and Reveal panel are available with optional stiffening beads. Stiffening beads are recommended for longer panel lengths. One or two beads are available.
PAC Flush panels shall be installed over a solid substrate with appropriate 30# felt or ice and water shield, or in limited applications over framing sections. When used in a windscreen application, panels must be fastened (stitched) through side joints. Consult a local architect/engineer for requirements of local codes and conditions.
Petersen Aluminum Flush panels are formed on precision roll-forming equipment that includes in-line Herr-Voss corrective levelers. Corrective leveling works to remove typical metal conditions including coil set, crowning and edge wave. In-line leveling capabilities allow us to work with source material that is “stillwater” flat. The result is a panel that exhibits superior flatness. Corrective leveling is available at no extra charge.
All flashing and trim shall be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032 – .063 gauge as specified) or PAC-CLAD steel (24 gauge or 22 gauge as specified). A 30-year non-prorated finish warranty can be supplied covering finish performance. Vinyl masking is recommended on all fabrication applications where extra handling is expected.